Changelog of firmwares 51.3 and 6.3 (Galileosky 7X, 10, XS EXT):
New features:
- Cyclic switching of autoinformer routes with a button is added.
- Support for devices with A7672E/G, A7682E cellular modules and SIM65M, SIM65M-C GNSS receivers is added.
- A GalileoSky protocol tag with the accelerometer auto-calibration state is added.
- Support for the DS1971 key is added.
- A packet size parameter is added to the ServerSocketSend and ServerSocketRecv EasyLogic functions (64 bytes by default, range 64–1472).
- The number of vehicle database activations is increased to 15, with 5 databases installed at a time.
- Three EasyLogic blocks are added: device LED setup, standard LED indication on/off, and internal battery charging on/off.
- A GalileoSky protocol tag with the MAC address of the Wi-Fi access point the device is connected to is added.
- LBS coordinates determined while parked are kept across a firmware restart.
- GalileoSky protocol tags with the longitudinal road slope, acceleration in vehicle axes, and calibration pad tilt correction are added, along with TILT and TILTCFG commands.
- An EasyLogic block that enables and disables writing points to the archive is added.
- The device calculates mileage and total fuel consumption from instantaneous CAN bus values (CANODO, CANODOCFG, CANFUEL, CANFUELCFG commands).
- Support for custom NTP servers for time sync is added.
- The CELLINFOPERIOD command is added to set the refresh period of cell environment data.
- The GSMMINUP command is added to set the minimum GSM modem uptime before a restart.
- The dwell time of each APN in alternating mode is set separately (APNTIMEOUT command).
Corrections:
- A hang of the built-in SIM868 GNSS receiver that caused the loss of coordinate output is fixed.
- Repeated recalculation of CAN tags with a user formula after a device restart is fixed.
- Detection of the forward direction during accelerometer auto-calibration is fixed.
- A spontaneous reset of the device settings to factory defaults is fixed.
- Data corruption when receiving over sockets in EasyLogic is fixed.
- Visibility of some BLE sensors is fixed: sensors transmitting data on a single advertising channel could remain undetected.
- A hang of the BLE radio is fixed.
- Parsing of a MAC address with separators in Bluetooth commands is fixed.
- A spontaneous reset of the total GPS/GLONASS mileage is fixed.
- Freezing of the cell environment data in records is fixed.
- Loss of the last character in the text of an incoming SMS is fixed.
- Freezing of the coordinates on devices with the ignition input configured is fixed.
- Loss of connection on multi-IMSI SIM cards is fixed.
- The PWM output frequency no longer jitters.
- Reading the archive from the SD card is fixed.
